OATAO - Open Archive Toulouse Archive Ouverte Open Access Week

Experimental study of coated carbide tools behaviour: application for Ti-5-5-5-3 turning

Wagner, Vincent and Baili, Maher and Dessein, Gilles and Lallement, Daniel Experimental study of coated carbide tools behaviour: application for Ti-5-5-5-3 turning. (2011) International Journal of Machining and Machinability of Materials, 9 (3/4). 233-248. ISSN 1748-5711

[img]
Preview
(Document in English)

PDF (Author's version) - Requires a PDF viewer such as GSview, Xpdf or Adobe Acrobat Reader
612kB

Official URL: http://dx.doi.org/10.1504/IJMMM.2011.039649

Abstract

The goal of this paper is to study the relation between the input data (conditions and geometry of cut) and answers (wear of tool, forces and cutting temperatures) when machining the Ti-5-5-5-3 alloy treated. This study has shown that the cutting process is different and that the slip forces are preponderates. Compared with other materials, the specific cutting pressure is higher and does not vary according to the cutting speed but depend on feed rate. Moreover, both edge preparation and feed rate have an influence on cutting force direction. Besides, cutting temperatures are high and almost similar to those provided by high speed machining with low cutting speed. Finally, we have shown that failure modes are different from those obtained when machining other titanium alloys. Built-up edge is the most deteriorating phenomenon and no flank wear was met in our study context.

Item Type:Article
Additional Information:Thanks to Inderscience editor. The definitive version is available at http://www.inderscience.com/offer.php?id=39649
HAL Id:hal-00797746
Audience (journal):International peer-reviewed journal
Uncontrolled Keywords:
Institution:Université de Toulouse > Institut National Polytechnique de Toulouse - Toulouse INP (FRANCE)
Other partners > SAFRAN (FRANCE)
Laboratory name:
Statistics:download
Deposited On:05 Mar 2013 15:57

Repository Staff Only: item control page