OATAO - Open Archive Toulouse Archive Ouverte Open Access Week

Effect of Ductile Damage Evolution in Sheet Metal Forming: Experimental and Numerical Investigations

Abbassi, Fethi and Pantalé, Olivier and Mistou, Sébastien and Zghal, Ali and Rakotomalala, Roger Effect of Ductile Damage Evolution in Sheet Metal Forming: Experimental and Numerical Investigations. (2010) Key Engineering Materials, 446. 157-169. ISSN 1662-9795

(Document in English)

PDF (Author's version) - Requires a PDF viewer such as GSview, Xpdf or Adobe Acrobat Reader

Official URL: http://dx.doi.org/10.4028/www.scientific.net/KEM.446.157


The numerical simulation based on the Finite Element Method (FEM) is widely used in academic institutes and in the industry. It is a useful tool to predict many phenomena present in the classical manufacturing forming processes such as necking, fracture, springback, buckling and wrinkling. But, the results of such numerical model depend strongly on the parameters of the constitutive behavior model. In the first part of this work, we focus on the traditional identification of the constitutive law using oriented tensile tests (0°, 45°, and 90° with respect to the rolling direction). A Digital Image Correlation (DIC) method is used in order to measure the displacements on the surface of the specimen and to analyze the necking evolution and the instability along the shear band. Therefore, bulge tests involving a number of die shapes (circular and elliptic) were developed. In a second step, a mixed numerical–experimental method is used for the identification of the plastic behavior of the stainless steel metal sheet. The initial parameters of the inverse identification were extracted from a uniaxial tensile test. The optimization procedure uses a combination of a Monte-Carlo and a Levenberg-Marquardt algorithm. In the second part of this work, according to some results obtained by SEM (Scaning Electron Microscopy) of the crack zones on the tensile specimens, a Gurson Tvergaard Needleman (GTN) ductile model of damage has been selected for the numerical simulations. This model was introduced in order to give informations concerning crack initiations during hydroforming. At the end of the paper, experimental and numerical comparisons of sheet metal forming applications are presented and validate the proposed approach.

Item Type:Article
Additional Information:Thanks to Trans Tech Publications editor. The original PDF of the article can be found at http://www.ttp.net/1013-9826.html
HAL Id:hal-04316329
Audience (journal):International peer-reviewed journal
Uncontrolled Keywords:
Institution:Other partners > Ecole Supérieure des Sciences et Techniques de Tunis - ESSTT (TUNISIA)
Université de Toulouse > Institut National Polytechnique de Toulouse - Toulouse INP (FRANCE)
Laboratory name:
Deposited On:04 Apr 2012 15:14

Repository Staff Only: item control page