OATAO - Open Archive Toulouse Archive Ouverte Open Access Week

An approach to modeling the chip thickness and cutter workpiece engagement region in 3 and 5 axis ball end milling

Sai, Lotfi and Belguith, Rami and Baili, Maher and Dessein, Gilles and Bouzid, Wassila An approach to modeling the chip thickness and cutter workpiece engagement region in 3 and 5 axis ball end milling. (2018) Journal of Manufacturing Processes, 34. 7-17. ISSN 1526-6125

[img]
Preview
(Document in English)

PDF (Author's version) - Requires a PDF viewer such as GSview, Xpdf or Adobe Acrobat Reader
2MB

Official URL: https://doi.org/10.1016/j.jmapro.2018.05.018

Abstract

The determination of the chip thickness in 5-axis ball end milling is most fundamental to calculate the cutting force which affects the machining stability and surface quality. In the 5-axis ball end milling, adding to the parameters of the 3-axis milling we have two important parameters which are the tilt and the lead angles. They affect the engagement region and the chip thickness and modify the cutting forces. Based on the true tooth trajectory and the machining surface geometries, this paper presents a new analytical model of the cutter workpiece engagement (CWE) region and the instantaneous undeformed chip thickness in three and five axis ball end milling. To validate the model a mechanistic force model was used, the simulation was compared to the measured one and a good agreement between them was proved.

Item Type:Article
HAL Id:hal-02053180
Audience (journal):International peer-reviewed journal
Uncontrolled Keywords:
Institution:Université de Toulouse > Institut National Polytechnique de Toulouse - Toulouse INP (FRANCE)
Other partners > Université de Sfax (TUNISIA)
Laboratory name:
Statistics:download
Deposited On:09 Jan 2019 15:28

Repository Staff Only: item control page