OATAO - Open Archive Toulouse Archive Ouverte Open Access Week

Study of Ti-1023 milling with toroidal tool

Wagner, Vincent and Duc, Emmanuel Study of Ti-1023 milling with toroidal tool. (2014) The International Journal of Advanced Manufacturing Technology. ISSN 0268-3768

(Document in English)

PDF (Author's version) - Requires a PDF viewer such as GSview, Xpdf or Adobe Acrobat Reader

Official URL: http://dx.doi.org/10.1007/s00170-014-6217-5


The Ti-1023 beta alloy titanium is used in aeronautics for the production of structure parts such as landing gear and as most of titanium alloys its machinability is poor explained by its physical and mechanical properties. This work presents the machinability results carried out for Ti-1023 milling in using toroidal tool. The aim of this research is the understanding of tool wear mechanisms and to establish the relation between cutting conditions, milling tool geometry, and tool life. A section is also devoted to the chip analysis. The wear modes are also analyzed and defined for different cutting tool geometries where several steps occur. This study is focus on material removal rate, tool life, and volume.

Item Type:Article
HAL Id:hal-01105355
Audience (journal):International peer-reviewed journal
Uncontrolled Keywords:
Institution:French research institutions > Centre National de la Recherche Scientifique - CNRS (FRANCE)
Université de Toulouse > Institut National Polytechnique de Toulouse - Toulouse INP (FRANCE)
Other partners > Université Blaise Pascal - UBP (FRANCE)
Other partners > Institut français de mécanique avancée - IFMA (FRANCE)
Laboratory name:
Deposited On:24 Sep 2014 13:14

Repository Staff Only: item control page