OATAO - Open Archive Toulouse Archive Ouverte Open Access Week

Discrete ply modelling of open hole tensile tests

Achard, Victor and Bouvet, Christophe and Castanié, Bruno and Chirol, Clément Discrete ply modelling of open hole tensile tests. (2014) Composite Structures, 113. 369-381. ISSN 0263-8223

(Document in English)

PDF (Author's version) - Requires a PDF viewer such as GSview, Xpdf or Adobe Acrobat Reader

Official URL: http://dx.doi.org/10.1016/j.compstruct.2014.03.031


The Discrete Ply Modelling (DPM) method, previously applied with success to out-of-plane loading such as impact or pull-through, is used to model open hole tensile tests. According to the literature, this kind of test is relevant to assess the efficiency of a modelling strategy. Four different stacking sequences are tested and the failure scenario and patterns are well predicted. The main advantages of DPM are the very small number of parameters required and the robustness of the models. The main drawback is the computation cost.

Item Type:Article
Additional Information:Thanks to Elsevier editor. The definitive version is available at http://www.sciencedirect.com The original PDF of the article can be found at Composite Structures website: http://www.sciencedirect.com/science/journal/02638223/113/supp/C
HAL Id:hal-01063573
Audience (journal):International peer-reviewed journal
Uncontrolled Keywords:
Institution:Other partners > Airbus (FRANCE)
Université de Toulouse > Ecole nationale supérieure des Mines d'Albi-Carmaux - IMT Mines Albi (FRANCE)
Université de Toulouse > Institut National des Sciences Appliquées de Toulouse - INSA (FRANCE)
Université de Toulouse > Institut Supérieur de l'Aéronautique et de l'Espace - ISAE-SUPAERO (FRANCE)
Université de Toulouse > Université Toulouse III - Paul Sabatier - UT3 (FRANCE)
Laboratory name:
Deposited On:12 Sep 2014 12:54

Repository Staff Only: item control page