OATAO - Open Archive Toulouse Archive Ouverte Open Access Week

Substrate Effect on the High Temperature Oxidation Behavior of a Pt-modified Aluminide Coating. Part II: Long-term Cyclic-oxidation Tests at 1,050 C

Vialas, Nadia and Monceau, Daniel Substrate Effect on the High Temperature Oxidation Behavior of a Pt-modified Aluminide Coating. Part II: Long-term Cyclic-oxidation Tests at 1,050 C. (2007) Oxidation of Metals, vol. 68 (n° 5 - 6). pp. 223-242. ISSN 0030-770X

[img]
Preview
(Document in English)

PDF (Author's version) - Requires a PDF viewer such as GSview, Xpdf or Adobe Acrobat Reader
1MB

Official URL: http://dx.doi.org/10.1007/s11085-007-9072-z

Abstract

This second part of a two-part study is devoted to the effect of the substrate on the long-term, cyclic-oxidation behavior at 1,050 C of RT22 industrial coating deposited on three Ni-base superalloys (CMSX-4, SCB, and IN792). Cyclicoxidation tests at 1,050 C were performed for up to 58 cycles of 300 h (i.e., 17,400 h of heating at 1,050 C). For such test conditions, interdiffusion between the coating and its substrate plays a larger role in the damage process of the system than during isothermal tests at 900, 1,050, and 1,150 C for 100 h and cyclicoxidation tests at 900 C which were reported in part I [N. Vialas and D. Monceau, Oxidation of Metals 66, 155 (2006)]. The results reported in the present paper show that interdiffusion has an important effect on long-term, cyclic-oxidation resistance, so that clear differences can be observed between different superalloys protected with the same aluminide coating. Net-mass-change (NMC) curves show the better cyclic-oxidation behavior of the RT22/IN792 system whereas uncoated CMSX-4 has the best cyclic-oxidation resistance among the three superalloys studied. The importance of the interactions between the superalloy substrate and its coating is then demonstrated. The effect of the substrate on cyclic-oxidation behavior is related to the extent of oxide scale spalling and to the evolution of microstructural features of the coatings tested. SEM examinations of coating surfaces and cross sections show that spalling on RT22/CMSX-4 and RT22/SCB was favored by the presence of deep voids localized at the coating/oxide interface. Some of these voids can act as nucleation sites for scale spallation. The formation of such interfacial voids was always observed when the b to c0 transformation leads to the formation of a two-phase b/c0 layer in contact with the alumina scale. On the contrary, no voids were observed in RT22/IN792, since this b to c0 transformation occurs gradually by an inward transformation of b leading to the formation of a continuous layer of c0 phase, parallel to the metal/scale interface.

Item Type:Article
Additional Information:Thanks to Springer Verlag editor. The definitive version is available at http://www.springerlink.com The original PDF of the article can be found at Oxidation of Metals website : http://www.springerlink.com/content/101598/?p=51e149839e404b9aa2af88a003f40f8a&pi=0
Audience (journal):International peer-reviewed journal
Uncontrolled Keywords:
Institution: Université de Toulouse > Institut National Polytechnique de Toulouse - INPT
Université de Toulouse > Université Paul Sabatier-Toulouse III - UPS
French research institutions > Centre National de la Recherche Scientifique - CNRS
Laboratory name:
Statistics:download
Deposited By: Celine Cabaup

Repository Staff Only: item control page